3m IR Emitter - 3.5mm Mono Plug
It connects using a 3.5mm jack (similar to a pair of standard headphones)
It is an IR transmitter, not a receiver
Two conductors on the the 3.5 mm jack
Length: 10 Feet
XBox One installation:
You can install this IR extension cable with Xbox One in a few simple steps:
1. Connect your IR extension cable to the IR port on the back of the Xbox One
2. Position the emitters near the devices you want to control. These may be designed to fit under the device near the IR window, or they may be sticky and adhere directly to the IR window
3. Test to make sure you can control the device. Reposition the emitters if necessary
This IR emitter can be used as part of an IR system to transmit IR commands to 2 pieces of AV equipment that are out of sight, such as in an AV cupboard. It should be suitable for use with any IR system. Simply place the IR emitters in front of, above or below or fixed on to the IR receivers on your source devices such as a Blu-Ray player or amp and any signals fed to the emitter will be blasted out to enable control.
Self-adhesive tape underneath the IR emitter for quick and easy fixing to any flat surface.
1x 3.5mm Jack Infrared
Allows you to control A/V component by the existing IR controller, such as amplifier, cable box, HD DVR, stereo receiver, Satellite TV receiver, CD player, DVD player, Bluray player or other components which are controlled by IR signal
Passes IR communication: Used with an IR Repeater kit to control a device; Extend remote control ability to any room in the house
Sticks directly onto the AV equipment; Two emitters on a single plug,Adhesive backing allows the emitter to be attached to the IR eye of a device
Dual Heads allow you to control multiple pieces of equipment with only one IR output, For use with Connecting Blocks and Home Automation controllers.
The mini stick-on emitter includes a 10 ft cable between the emitter heads and the mini-plug